Product Overview

The GE Fanuc IC695PNC001CA functions as the primary PROFINET interface for the PACSystems RX3i controller platform. This module enables the CPU to manage high-speed remote I/O and third-party PROFINET devices over an industrial Ethernet backbone. It occupies a single slot on the RX3i universal backplane and utilizes the high-speed PCI bus for rapid data throughput. We offer this unit as 100% Brand New in original factory packaging, ensuring maximum reliability for your automation architecture.

Technical Specifications

Engineering Advantages

Optimized Bandwidth Management
The IC695PNC001CA uses specialized hardware to handle PROFINET communication cycles independently. This offloads the communication task from the main CPU, ensuring consistent logic execution times even during heavy network traffic.

Flexible Ring Topologies
The dual-port design supports Media Redundancy Protocol (MRP). This allows you to wire devices in a ring; if a cable breaks, the system reroutes data in milliseconds to prevent a total system shutdown.

Streamlined Commissioning
The module supports “Discovery and Configuration Protocol” (DCP). This feature allows engineers to assign IP addresses and names to remote devices directly through the PAC Machine Edition software without manual DIP switch settings.

Enhanced Diagnostics
Each port features dedicated LEDs that indicate link status, speed, and collision data. Furthermore, the module reports detailed PROFINET alarm data back to the CPU for display on HMI screens.

FAQs

Does the IC695PNC001CA support third-party PROFINET devices?
Yes, this controller is fully compliant with PROFINET standards. You can integrate any GSDML-compliant device, such as variable frequency drives (VFDs), sensors, or remote I/O blocks from other manufacturers.

Where should I install this module in the RX3i rack?
You must install the IC695PNC001CA in a Universal Backplane (IC695). It requires the high-speed PCI bus connectors found in the universal slots to communicate with the RX3i CPU.

How many PROFINET controllers can I use in one RX3i system?
The system allows for multiple PROFINET controllers within a single rack, depending on the CPU model and power supply capacity. This allows you to segregate different production cells into separate networks.

Can I replace an older version with the “CA” revision?
Yes, the “CA” revision is the direct replacement for earlier hardware versions. It provides superior component stability and is fully compatible with existing PROFINET configurations.